Lisp : Settingout Table

Settingout with Table Lisp help you while creating setting out drawing , It will create a coordinate table and elevation (X,Y,Z) according to the coordinate points placed in the drawing.

Steps :

• Download Settingout with Table Lisp Click here...
  

• Load Settingout Table Lisp
• Type Command “CN” to place Increment Settingout Points

• If need to create some sub points, Type “CSN” to place Increment Settingout sub Points. This also allows to create sub points after placing all increment Settingout points.

•  After placing points type command “CRT” to create Table

•  Type “A” to select all Points
• Then Pick a point on your Layout to place table. This will automatically create a table with all coordinates placed under the model space. The Settingout table will automatically create the table with an ascending order.

Specification:

• It will create new test style “Gen-text”
• It will create an attribute block “CRBLK”
• It will Place Points in new layer “Coordinate Points”
• It will place Table in new layer “Coordinate Table”
• It will automatically change “UCS to World” and back to “previous”

Steps to Edit Coordinate Points

• If the alignment of drawing changed and need to edit some points Settingout value,
• Move the points according to the setting out,
• Type command “CRT” to create new edited Settingout table

• Type “S” to select modified  Points
• Then Pick a point on your Layout to place new table. This newly table will create only those Settingout values of the changed points.

• And replace the newly Settingout table values with the existing values.

Note:

• This Lisp is crated to place Settingout points up to “99” only,  If you have points more than 100, pursue following steps.
• Settingout Table lisp will count all “CRBLK” block and extract data of each Block to create Table.
• Place points up to “99” the run command “CRT” to place table.
• After that type command “RENAME”  and rename block “CRBLK” to “CRBLK-1”.
• Then continue placing points from “100”  and run command “CRT” to create new table starting form 100.

Errors:

• While using  “sub points” order of points may not be in the ascending order, so adjust manually to make it in an ascending order. 

Related Post : Coordinate With Table